Woodstock Shop Fox W1694 Instruction Manual - Test Run
OPERATIONS
-22-
Once assembly is complete, the machine is
ready for a test run. The purpose of a test run is
to identify any unusual noises and vibrations, as
well as to confirm that the machine is perform-
ing as intended.
To test run the Model W1694, do these steps:
1.
Make sure that all tools have been removed
from the jointer.
2.
Turn the jointer ON.
3.
Once the jointer is running, listen for any
unusual noises. The machine should run
smoothly with little or no vibrations.
• If there are any unusual noises or vibra-
tions, stop the jointer immediately by
pushing the paddle switch down.
4.
Unplug the jointer and investigate the
source of the noise or vibration. DO NOT
make any adjustments to the jointer while
it is plugged in. The jointer should not be
run any further until the problems are cor-
rected.
THIS MACHINE produces
sawdust that may cause
allergic reactions or res-
piratory problems. Wear
a dust mask or respirator
in addition to using a dust
collector.
THIS MACHINE throws
wood chips and sawdust.
Wear safety glasses or a
face shield during all
operations.
KEEP loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.