Woodstock Shop Fox W1694 Instruction Manual - Depth of Cut
Manual is about: 6" BENCH TOP JOINTER
of
44
ADJUSTMENTS
-20-
The depth of cut is equal to the distance
between the infeed table surface and the top of
the cutterhead blade at top-dead-center
(
Figure 28). The depth of cut is adjusted by
raising and lowering the infeed table.
To adjust the depth of cut:
•
Turn the table height knob (
Figure 29)
clockwise to raise the infeed table, thereby
reducing the depth of cut.
•
Turn the knob counter-clockwise to lower
the infeed table, thereby increasing the
depth of cut.
Never remove more than
1
⁄
8
" of material from
the workpiece in a single pass.
Figure 29. Table height knob.
Figure 28. Depth of cut.
Depth Of Cut
Depth Of Cut