Woodstock Shop Fox W1679 Instruction Manual - Belt Guard

ASSEMBLY

-15-

Figure 18. Attach belt guard to stand 

with the hex bolt.

Belt Guard

Attach the belt cover to the cabinet stand with

the

5

⁄

16

"-18 x 2

1

⁄

2

" hex bolt as shown in Figure

18.

Knife Gauge

The knife gauge consists of a steel rod, two

adjuster arms and two E-clips. 

To assemble the knife gauge:

1.

Insert the steel rod through each adjuster

arm.

2.

Snap the E-clips into the grooves at the ends

of the steel rod so your assembly looks like

the knife gauge shown in Figure 19. 

See page 16-17 for usage instructions.

Control Pedestal

1.

Mount the control pedestal to the back of

the cabinet stand as shown in Figure 20.

2.

Secure the control pedestal with the (4)

5

⁄

16

" hex nuts and (4) 

5

⁄

16

" washers from the

hardware bag.

Figure 19. Knife setting gauge.

Figure 20. Mounting pedestal switch to stand.

Make sure that your

machine is unplugged

during all assembly pro-

cedures! If this warning

is ignored, serious per-

sonal injury may occur.