Woodstock Shop Fox W1679 Instruction Manual - Dust Port

ASSEMBLY

-13-

Figure 12. Pulley and V-belt alignment.

Figure 13. Dust port mounting holes.

4.

Halfway between the two pulleys, lightly

squeeze each side of the belt together to

check the tension. 

Belt too loose? If each side of the belt

squeezes toward each other more than 

1

⁄

2

",

increase the tension by repeating steps 2

and 3. 

DO NOT over-tighten the belt! Do not use

pry bars or any other device to force the

motor down as this may over-tighten the

belt, which may damage the balance of the

motor shaft or bearings and increase the

wear of the power transfer components.

5.

Check the V-belt pulley alignment. Minor

adjustments may be made by loosening the

pulley setscrew and sliding the pulley along

the shaft. See Figure 12 for details.

Dust Port

Using the (4) phillips head screws from the hard-

ware bag, attach the dust port over the dust

chute at the mounting holes shown in Figure 13.

Installing Fence

3.

Locate the threaded hole on the back of the

infeed side of the fence and install the

fence tilt knob into the fence.

Figure 14. Installing key into fence support.

1.

The fence support key has a roll pin fitted in

the center. Install the key into the fence

support keyway and fit the roll pin into the

provided hole. Figure 14 shows the key

installed correctly.

2.

Get a friend to help you lift and place the

fence on this support.

Do not slide the fence across the outfeed

table. Scratching will result. 

NOTICE

Key

Fence

Support