Woodstock Shop Fox W1679 Instruction Manual - Installing V-Belt

Figure 11.

Motor mount bolts inside 

dust chute (two are not shown).

Installing V-Belt

ASSEMBLY

-12-

Beginning

Although the main components of the Shop Fox

®

W1679 are assembled at the factory, some

assembly is required. The following series of

instructions are the recommended sequence

best suited for final assembly.

Mounting Jointer

1.

Determine the best place for the jointer in

your shop and place the cabinet stand in

that location.

2.

With the help of a friend, lift the jointer

assembly onto the stand so the cutterhead

pulley is positioned directly over the slot in

the top of the stand.

3.

Align the mounting holes (shown in Figure

10) on the stand to the jointer assembly,

and secure the jointer assembly with the (3)

3

⁄

8

" - 16 x 

3

⁄

4

" 

hex bolts and lock washers

from the hardware bag.

Figure 10. Secure table to stand at these locations.

Make sure that your

machine is unplugged

during all assembly pro-

cedures! If this warning

is ignored, serious per-

sonal injury may occur.

1.

Figure 11 shows the jointer motor mount

bolts inside of the dust chute. Loosen the

nuts so you can slide the motor up and

install the V-belt.

2.

With the V-belt in the grooves of both the

motor pulley and the cutterhead pulley,

pull the motor down tightly by hand and

tighten one corner bolt. 

3.

Place your straightedge against the face of

both pulleys, and swivel the motor as nec-

essary until both pulleys line up with each

other. Tighten the other three motor mount

bolts.