Woodstock Shop Fox W1666 Instruction Manual - 110V Operation (W1685)
-11-
DO NOT attempt to work on your elec-
trical system if you are unsure about
electrical codes and wiring! Seek
assistance from a qualified electri-
cian. Ignoring this warning can cause
electrocution!
110V Operation (W1685)
When it is necessary to use an extension cord, use the
following guidelines:
• Use cords rated for standard service.
• Use cords under 50 feet of length.
• Use cords with 14 ga. wire or bigger.
• Ensure cord has a ground wire and pin.
Extension Cords
Grounding
This machine must be grounded! The plug attached to
the electrical cord supplied with this machine comes
with a grounding pin. Do not remove it. If your outlet
does not accommodate a ground pin, have it replaced
by a qualified electrician or have an appropriate adapter
installed.
Note: When using an adapter, the adapter must be
grounded.
The Model W1685 1
1
/
2
HP dust collector operates at 110
volts only, and draws up to 16 amps.
Make sure that the power supply circuit this machine
is connected to meets local and federal electrical code
requirements. Seek assistance from a qualified electri-
cian if you are unsure about electrical codes and wiring!
220V Operation (W1666)
The Model W1666 2 HP dust collector operates at 220V
only, and draws up to 12 amps. Connect a 220V 6-15
plug and outlet for your power connection (see
Figure
7).
Make sure that the power supply circuit this machine
is connected to meets local and federal electrical code
requirements. Seek assistance from a qualified electri-
cian if you are unsure about electrical codes and wiring!
ELECTRICAL
ELECTRICAL
W1666, W1685 Dust Collectors
This equipment must be grounded.
Under no circumstances should the
grounding pin from any three-pronged
plug be removed or electrocution may
occur.
6-15P
6-15R
Figure 7. A 220V 6-15 plug and outlet.