Woodstock M1109 Owner's Manual - Parts
-43-
M1109 Combo Lathe/Mill
SE
RV
IC
E
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
Loud, repetitious
noise coming
from machine
at or near the
motor.
1. Pulley setscrews or keys are missing or loose.
2. Motor fan is hitting the cover.
1. Inspect keys and setscrews. Replace or tighten if
necessary.
2. Tighten fan or shim cover, or replace items.
Carriage hard to
move.
1. Carriage lock is tightened down.
2. Chips have loaded up on bedways.
3. Bedways are dry and in need of lubrication.
4. Longitudinal stops are interfering.
5. Gibs are too tight.
1. Check to make sure table locks are fully released.
2. Frequently clean away chips that load up during
turning operations.
3. Lubricate bedways and handles.
4. Check to make sure that stops are floating and not
hitting the center stop.
5. Loosen gib screw(s) slightly.
Gear change
levers will not
shift into posi-
tion.
1. Gears not aligned in headstock.
1. Rotate spindle by hand until gear falls into place.
Motor overheats. 1. Motor overloaded.
2. Air circulation through the motor restricted.
1. Reduce load on motor.
2. Clean out motor to provide normal air circulation.
Loud, repetitious
noise coming
from machine.
1. Gears not aligned in headstock or no back-
lash.
2. Broken gear or bad bearing.
3. Workpiece is hitting stationary object.
1. Adjust gears and establish backlash.
2. Replace broken gear or bearing.
3. Stop lathe immediately and correct interference
problem.
Tailstock quill
will not feed out
of tailstock.
1. Quill lock lever is tightened down.
1. Turn lever counterclockwise.
Motor is loud
when cutting.
Overheats or
bogs down in the
cut.
1. Excessive depth of cut or feed rate.
2. RPM or feed rate wrong for cutting
operation.
3. Cutting tool is dull.
4. Gear setup is too tight, causing them to
bind.
1. Decrease depth of cut or feed rate.
2. Refer to RPM feed rate chart for appropriate rates.
3. Sharpen or replace the cutting tool.
4. Readjust the gear setup with a small amount of
backlash so the gears move freely and smoothly
when the chuck is rotated by hand.