Woodstock H0625 Instruction Manual - Operations
-16-
OPERATIONS
Once assembly is complete and adjustments are
done to your satisfaction, you are ready to test
run the machine.
Make sure the starting switch is off. The pad-
dle is down for off. Make sure all the fasteners
and lock handles are tight. Plug in the power
cord. Pull the START paddle. Make sure that
your finger is poised over the paddle, Figure 27,
just in case there is a problem. The drill press
should run smoothly, with little or no vibration
or rubbing noises. Strange or unnatural noises
require you to stop the machine, wait for it to
stop moving, unplug the machine, investigate
and correct before further operation.
If the source of an unusual noise or vibration is
not readily apparent, contact our service
department for help at 1-360-734-3482 or at
tech-support@woodstockint.com.
Test Run
DO NOT investigate or
adjust the machine while
it is running. Wait until
the machine is turned off,
unplugged and all working
parts have come to a stop
before proceeding!
Figure 27. Hand poised over stop paddle.
Always wear safety glass-
es when operating drill
press. Failure to comply
may result in serious per-
sonal injury.