Woodstock H0625 Instruction Manual - Table Adjustments
-15-
Table Adjustments
The table can be adjusted to accommodate
height of materials to be sanded or drilled. To
adjust:
1. Hold onto the table with one hand and
loosen the table lock knob. Lift or lower to
the desired height. Tighten the table lock
knob. Figure 24.
2.
The drill press is supplied with 4 table
inserts. Always choose the insert whose
opening is only slightly bigger than the sand-
ing drum chosen. Figure 25. For drilling,
always use the table insert with the small-
est opening. Install the chosen table insert
into the pocket provided in the top of the
table.
3.
The table should be adjusted so the opening
in the installed table insert is centered to
the drill bit or sanding drum. Loosen the
table and pivot the table until the bit or
drum is centered.
4. The table can be adjusted out of the way so
the base of the drill press may be used to
support the workpiece for drilling opera-
tions only. Loosen the table lock knob and
pivot the table to the back side of the col-
umn. Figure 26.
A table insert is not needed when a 2" drum is
used.
Sanding Tip: To use all of the grit on the paper,
adjust the table height as the paper wears.
When the thickness of the workpiece does not
allow much table movement, remove the drum
from the sanding spindle, turn it end for end and
replace it on the sanding spindle.
Figure 24. Support table while loosening lock.
Figure 25. Checking drum size and table insert.
Figure 26. Table adjusted behind column.
Support table before loos-
ening lock knob. The weight
of the table combined with
a workpiece could result in
a crushing injury.