Woodstock H0625 Instruction Manual - Speed Change
-12-
Speed Change
ADJUSTMENTS
Unplug the drill press before changing speeds.
The Oscillating Drill Press has 5 speeds ranging
from 620 to 3100 RPM. Refer to the speed charts
located under the belt guard while following the
instructions below.
1. Loosen the belt tension lock. Figure 15.
2.
The motor is now free to move and can be
pulled toward the front of the drill press.
This will take tension off the V-belt.
3.
The speed chart is located under the belt
cover. Locate the desired speed and move
the V-belt to the desired V-grooves on the
motor and spindle pulleys. Figure 16.
4.
Push the motor toward the back of the
headstock, the motor support rod is spring
loaded and will follow the motor. Figure
17. Tighten the lock knob.
5.
Close the cover. The motor will not start
until the cover is closed.
Figure 15. Loosening the lock knob.
Figure 16. Adjusting belt to desired speed.
Figure 17. Motor support rod follows motor.
Unplug the drill press
before changing speeds
to avoid accidental start
up. Failure to do this may
result in serious personal
injury.
See page 22 for clear illustration of speed
charts.