Woodstock H0625 Instruction Manual - Handles
-11-
Handles
Three handles are supplied with your new
Oscillating Drill Press. Thread them into the hub
as shown in Figure 14.
Figure 14. Spindle handles installation.
Drill Chuck
Figure 13. Inserting the lock screw.
Figure 12. Jaws adjusted inside chuck body.
The drill chuck is attached to the drill spindle by
means of a matched taper and screw. To mount
the drill chuck to the spindle, carefully follow
the instructions below:
1. The drill chuck and spindle must be thor-
oughly cleaned before assembly. It is rec-
ommended that mineral spirits be used for
this task. Refer to the safety warnings on
the container. Failure to clean the mating
surfaces may result in separation and wear.
2.
Use the chuck key provided to adjust the
jaws of the chuck until they are well inside
the drill chuck body. Figure 12.
3. Place the drill chuck on the spindle. Insert
the Allen
®
head cap screw into the hole of
the drill chuck as in Figure 13. Tighten the
screw. The drill chuck should be seated
securely on the spindle at this time and
should be checked for looseness. If the
chuck fails to remain secure on the spindle,
repeat step 1.
Unplug machine and
remove handles before
using the oscillating fea-
ture. Handles swing dur-
ing operation.
DO NOT use a hammer on the drill chuck to
seat it onto the spindle. Damage will occur to
the oscillating mechanism.