Thermador C271 Service Manual - page 54

THE HI-TEMP CUTOUT

The hi-temp cutout contacts open at or above 350˚F

±

8˚, and are manually reset by pressing the reset

button.

Refer to page 2-18 to access the hi-temp cutout.

1.

With no power applied, remove the wires from

the terminals of the hi-temp cutout.

2.

Set the ohmmeter to  the R x 1 scale.

3.

Touch the ohmmeter leads to the terminals. The

meter should indicate continuity.

4.

If the reading is not correct, remove and replace

the hi-temp cutout.

Terminals

Hi-Temp Cutout

Reset Button

THE CONVECTION

BAKE ELEMENT

Refer to page 2-7 to access the convection bake

element.

1.

With no power applied, remove the wires from

the terminals of the convection bake element.

2.

Set the ohmmeter to  the R x 1 scale.

3.

Touch the ohmmeter leads to the convection

bake element terminals. The meter should indi-

cate 18 

Ω

.

4.

If the reading is not correct, remove and replace

the convection bake element.

Page 52