Thermador C271 Service Manual - Removing The Control Panel

REMOVING THE CONTROL PANEL

(“C” MODEL OVENS ONLY)

1.

Turn off the electrical power to the oven.

2.

Pull the oven out of its mounting location

just far enough to access the front and rear

plenum covers.

3.

Remove the plenum front and rear cov-

ers (see Figure 14).

Refer to  Figure 15 on the next page for the

following steps:

4.

Open the upper oven door.

5.

Remove the bottom screw from the con-

trol panel.

6.

Remove the mounting screw from the

detent pin clip and unhook the clip  from

the detent pin (see inset 1).

7.

Turn the latch 90˚ so that the sides align

with the cutout in the latch catch (see in-

set 2).

8.

Rotate the bottom of the control panel as-

sembly out and unhook the detent pins

from the pivot bracket slots (see inset 1).

9.

Unplug the orange and yellow 9-wire con-

nectors from the relay board at P10 and

P11.

10. Unplug connectors P2 and P6 from the

display head.

WARNING

Turn off the electrical power circuit to the

oven at the main junction box before ser-

vicing this unit.

When you work on the oven, be careful

when handling the sheet metal parts. There

are sharp edges present and you can cut

yourself if you are not careful.

CAUTION

REAR COVER

FRONT COVER

Figure 14

Page 31