Tascam FW-1884 Supplementary Manual - page 5
Cubase SX/SL / Nuendo (Win/Mac): EQ (Mackie Control Mode)
TASCAM FW-1884
5
EQ (Mackie Control Mode)
1
Press
AUX 2
to enable EQ adjustment mode on
the FW-1884.
2
Press
AUX 3
(page down) to set Frequency and
Gain adjustment for all 4 bands using the chan-
nel encoders. Encoders 1-8 correspond as fol-
lows:
1=Lo Freq
2=Lo Gain
3=Lo-Mid Freq
4=Lo-Mid Gain
5=Hi-Mid Freq
6=Hi-Mid Gain
7=Hi-Freq
8=Hi Gain
3
Press
AUX 4
(page up) to enable/disable and set
the Q for each band. Encoders 1-8 correspond as
follows:
1=Lo on/off
2=Lo Q
3=Lo-Mid on/off
4=Lo-Mid Q
5= Hi-Mid on/off
6=Hi-Mid Q
7=Hi on/off
8=Hi-Q.
Encoder settings
Aux 3 and 4
function as “Page Down” and “Page
Up” controls for features that would otherwise
use multiple “Pages” of encoder settings dis-
played on a scribble strip. These functions
include Pan, EQ, Sends levels and effects, Insert
Plug-Ins, Sends effects parameters, VST Instru-
ment parameters, Master effects parameters.
NOTE
The functions below are multi-page functions that are
best used while viewing the appropriate panel in the
DAW display. Use the Aux 3 and Aux 4 buttons as
described above to navigate the various pages.
Aux 5
uses the channel encoders to set 'SENDS'
levels.
Page 1 - Level for sends 1 through 8 on FW-
1884 encoders 1 - 8.
Page 2 - Send on/off for sends 1 through 8.
Page 3 - Send pre/post for sends 1 through 8.
Page 4 - Effects bus select for effects busses 1
through 8.
Aux 6
uses channel encoders to set “Insert” Plug-In
parameters.
Page 1 - Select Insert #, Insert on/off, Effect type
(encoders 3-5), encoders 6-8 not used
Page 2 - various effect parameters dependent on
effect type selected above
Page 3 - continuation of page 2. Actual number
of pages will depend on effect type.
F8
Uses channel encoders to set parameters of the
effect chosen by Aux 5 (Sends).
Page 1 - Select Send #, Effect on/off, encoders 3-
8 not used
Page 2 - various effect parameters dependent on
effect type selected above
Page 3 - continuation of page 2. Actual number
of pages will depend on effect type.
F9
Uses channel encoders to set parameters of VST
Instruments.
Page 1 - VST Instrument #, on/off, encoders 3-8
not used
Page 2 - various parameters dependent on
instrument type selected above
Page 3 - continuation of page 2. Actual number
of pages will depend on instrument.