Tally T8006 User Manual - Replacing Toner Cartridges
61
Chapter 6
Maintaining Your Printer
When supplies such as toner cartridges and fuser oil need replacement,
and when printer parts need replacement after high-volume printing
(approximately 100,000 to 600,000 pages), the control panel displays
messages.
See
“Chapter 4 Operating Your Printer” on page 37, and “Appendix D
Control Panel Messages” on page 141for more information about control
panel messages.
Printer parts must be replaced by a qualified Tally Service Technician. For
more information on part replacement, see “Appendix B Periodic
Replacement Parts” on page 117.
For more information about supply orders, see the Tally T8006/T8306
Color Laser Printers Quick Start Guide on the Tally CD-ROM.
Perform the following steps to replenish the supplies in your printer.
Warning!
Make sure the power switch is off, and that the printer has
cooled for a minimum of 30 minutes before supplies near the fusing unit.
Replacing Toner Cartridges
Replace toner cartridges at least once every 12 months, or more often
depending on usage. At a 5% coverage rate and continuous printing of
letter-size paper, T8006 toner cartridges can print about 12,000 pages for
black (
K
), and 7,200 pages for color (
C
,
M
and
Y
). The T8306 toner
cartridges can print about 14,000 pages for black (
K
), and 8,500 pages for
color (
C
,
M
and
Y
).
Note:
The original toner cartridges from the Starter Kit are filled at half
volume for first-time installation only. Their early replacement does not reflect
the replacement cycle stated above.
Warning!
If you get toner in your eyes, immediately flush your eyes with water for at
least 15 minutes, and contact a physician.