Tally T8006 User Manual - page 166

Tally T8006/T8306 Color Laser Printer User Guide

160

Activate the BOOTP daemon (usually 

bootpd)

.

The printer will not use the new configuration until the printer is 

restarted. 

Note:  

The “ha” field is a network interface Ethernet address. The “ip” 

field is an IP address. The “gw” field and “sm” field correspond to the default 

router address and net mask (DEF_ROUT and NET_MASK 

parameters), respectively. 

Setting with DHCP

Your printer comes with DHCP turned off by default. To set up TCP/IP 

using DHCP, you must turn on DHCP using NetPilot, or by accessing 

one of the printer’s TCP/IP based servers through a static IP address.

Whatever method you use to set up TCP/IP, you should confirm the 

connection by using the 

ping

 utility:

Confirm the settings by using the network test button located on the back 

of the printer.

Configuring the Printer Using HTTP

To use the Web browser, the TCP/IP must already be configured on the 

printer. 

To access the printer’s HTTP server, type in the network address or host 

name (if defined) of your printer in your browser’s location bar. 

There are six configuration pages that you can use to set up your printer. 

Configuration

The Configuration page allows you to change the access settings of the 

printer.

Management

The Management page enables you to view basic information about the 

network interface (version of the current network interface software, 

Ethernet address, base URL address, and whether the network protocol is 

valid). 

The Management page also enables you to reset the network interface or 

to set the parameters to the factory-set default values. 

ping host-name or IP-address