Talkswitch TS-400 User Manual - page 10
6
H T T P : / / G LO B A L .T A L K S W I T C H . C O M
T S - 4 0 0 U S E R G U I D E
CONFIGURING YOUR TS-400
To configure your TS-400, press
.
Configuring 7- an d 10-digit Dialling
For use outside of North America, do not program any area codes. When calling from
the Caller ID (CLID) list, numbers will be dialled exactly as received from the network.
Configure outside line access
The display indicates the OUTSIDE ACCESS? prompt.
Enter the outside line access code (up to 4 digits), or press
if your extension is configured for direct line access.
Press the
button.
If you enter an outside line access code by mistake, press the
button or the
W
button to delete the digits.
Configure Paging
Press
to configure for External Paging or press
to
configure for Group Paging to telephone sets. If you select Group
Paging, you must also enter a ring group number (300–309).
ADJUSTING THE DISPLAY ANGLE
You can optimize the LCD display by adjusting the viewing angle. To adjust the LCD
viewing angle, move the rear edge of the LCD module up or down.
ADJUSTING THE DISPLAY CONTRAST
The display can be adjusted to suit the light level of your room and your viewing
preference. To make the contrast of the display lighter or darker, press the
button
to the right of the screen until the desired contrast is reached.
ADJUSTING THE HANDSET RECEIVER VOLUME
If you need to adjust the handset receiver volume:
1. Lift the handset and listen to the dial tone.
2. Press the right side of the
button to increase the receiver volume.
3. Press the left side of the
button to decrease the receiver volume.
4. Replace the handset when the desired receiver volume is reached.
VO LUM E
VO LUM E
2
1
D E L ET E
D I A L / E NT E R
#
M E N U
_ _ _ _
OUTSIDE ACCESS?
9 _ _ _
OUTSIDE ACCESS?
_
>1=PA
2=GROUP