Sentry RMC10 Using Manual - page 2

6. The red led indicator will keep on flashing till your device (TV, VCR etc) turns off. 

7. Press and release enter to Install the code. 

CODE RETRIEVAL:

1. Manually turn on the device (TV, VCR etc) to be controlled. 

2. Press and hold the CODE SEARCH button until the red Indicator stays on, then 

release the CODE SEARCH. 

3. Press the device control (TV, VCR etc) you want to control. 

4. Press the CODE SEARCH button again and the red indicator should blink once. 

5. Follow the sequence of (0-9)and press once for each number button until the 

Indicator flashes one time. 

6. Repeat the procedure 5 till 3 correct codes are confirmed. 

7. If the red indicator light flashes, than you have entered an incorrect number, and 

please follow the sequence (0-9). 

NOTE: IF YOUR UNLISTED DEVICE CONTINUES NOT TO RESPOND AFTER FOLLOWING 

THESE INSTRUCTIONS, PLEASE CONTACT THE MANUFACTURE OF THE UNLISTED 

DEVICE IN ORDER TO OBTAIN THE CORRECT CODES.