Sentry GSM-DE3100 User Manual - page 10
10
LED INDICATORS
LED Status Indicator
Red Flashing = Standby
Red Solid = Using
LED Network Indicator
Red flashes once per 3 seconds = Ready
Red flashes once per second = Searching
Red Solid = Busy
LED Power Indicator
Red Solid = Power On
Red Off = Power Off
ADDING ADMINS & USERS
ADDING ADMINS
The system has the ability to store one (1) Power Admin and three (3) Admins, where the Power Admin is an upgraded status for SMS programming
and confirmation.
Note: An Admin must be added into the system before adding users or changing settings. One of the Admins must be used to be upgraded to a
Power Admin. When registering a user for dialing in, the owner has to add the country code “1” before the phone number.
The default Passcode is 1234.
1) Use your cell phone to dial into the system by entering the phone number of the SIM Card installed in the system. You will hear a long
tone when the door system answers the call.
2) To add first Admin, enter:
12 1234
#
11 1phonenumber
#
To add a second Admin, enter:
12 1234
#
12 1phonenumber
#
To add a third Admin, enter:
12 1234
#
13 1phonenumber
#
Note: Successful key code acceptance is followed by one long tone. Unsuccessful key code is followed by three short tones. There is no
option to delete an Admin, but an Admin can be overwritten.
Example 1: An Admin wants to register Admin 11 into the system. His phone number is 999‐555‐1234.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Enter Program
Mode
Admin Passcode
End Passcode
Admin
(11, 12, 13)
Country Code + Telephone Number
(11 digits ‐‐ including country code 1 &
phone number with area code)
End
12
1234
#
11
1 999 555 1234
#
UPGRADING AN ADMIN TO POWER ADMIN
To upgrade an Admin to a Power Admin, enter Admin Program Mode ( 12 ) then use function code 74.
To upgrade Admin to Power Admin
for SMS programmability, enter:
12 1234
#
74 1phonenumber
#
To remove Power Admin status
for SMS programmability, enter:
12 1234
#
74 1phonenumber
#
Example 2: An Admin wants to upgrade Admin 11 to Power Admin.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Enter Program
Mode
Admin Passcode
End Passcode
Function Code
Country Code + Telephone Number
(11 digits ‐‐ including country code 1 &
phone number with area code)
End
12
1234
#
74
1 999 555 1234
#
ADDING USERS
An Admin has the responsibility of adding users into the system.
To add User 1, enter:
12 1234
#
72 1 1phonenumber
#
To add User 2, enter:
12 1234
#
72 2 1phonenumber
#
To add User 9, enter:
12 1234
#
72 9 1phonenumber
#
Input 1‐100 user IDs; 3 digit place holders not necessary
Note: SMS texts are limited to
140 characters per message
when using SMS programming.