Sentinel VI350 Instruction Manual - page 17
Page 17 of 31
VI350-MANUAL-EN.R1.doc
• When the Call button on the camera is pressed, All monitors in the
system will ring the doorbell chime and turn the screen ON.
• After the call, if the “Speak-out” or “Two-way” button is not pressed, it will
cutoff after 30 seconds.
• If the “Speak-out” or “Two-way” button is pressed you have 90 seconds
to communicate before it automatically cuts off, or press the “Cut off”
button to terminate a call at any time.
2
Audio & Video Monitoring
• Press the Monitor button
for monitoring a camera manually
• Press button again to switch the monitoring channel (If there is more
than one camera connected)
• Press the “Cut off” button to end the monitoring mode
3
Intercom Function between Monitors
• Press the “Intercom” button
from any monitor to generate a call
signal at all monitor locations (i.e. expansion monitor)
• From another monitor respond to a call signal by pressing the “Two way”
button. The calling monitor and responding monitor can then engage in
the voice intercom function. The intercom LED will turn ON at all monitor
locations to indicate the intercom function is engaged.
NOTE
Only 2 monitors are allowed in this function.
Now 2 monitors can talk to each other, “hands-free”. This function will
be terminated automatically after 90 sec, or when the “cut off” button is
pressed, or when the calling button on the outdoor camera is pressed.
4
Door Release Function
• Pressing the “Door Open” button
at the monitor (which must be
online), will activate the door strike at the online camera. (Door strike
EDS350 sold separately).
• The “Door Open” button at an offline monitor cannot activate this
function.