Sensica sensiLight User Manual - Working With Sensilight™
9
eyebrows, or eyelashes as this could
cause serious eye damage.
Working with sensiLight™
Note: A preliminary test should be
conducted before proceeding to a full
treatment. See “preliminary test section”
below.
sensiLight™ should ideally be used on areas
such as your underarms, bikini line, arms,
back, shoulders, chest, legs and on allowed
facial areas.
1. To turn sensiLight™ on, press the ON/OFF
button (see image - item
1
). Energy level 1
green indicator will light on.
2. The device sets itself on the lowest energy
level - level one. For other energy levels
press the Energy level selection button.
3. You may decrease or increase the energy
level according to your convenience
(to reach the level determined in the
preliminary test section). The energy level
lights will light up green on the level scale
according to the selected energy level.
4. Place sensiLight™ treatment window (see
image - item
6
) on the desired body area
with full contact to the skin. If sensiLight™
is not properly applied or your skin tone
is too dark/tanned, the indicator light on
the applicator will be “blinking” red. In this
case, sensiLight™ will not trigger a pulse
in that area of skin.
5. Press the trigger button (see image - item
2
) and hold it pressed for continuous
pulsing.
6. Press the trigger button once for single
pulse.
7. While pressing the trigger button, you
will see a bright flash, you will hear a
popping noise, and you may feel a mild
stinging and/or heat sensation.
8. Keep the trigger button pressed and start
moving the device with each pulse to
the next spot without detaching it from
the skin. The device will immediately
recharge and will be ready for the next
pulse. Repeat process until the entire
treatment area has been covered.