Safety Vision PatrolRecorder 4C Installation Manual - page 7
PatrolRecorder
™
4C Installation Guide
October 2009
~
Connect the swivel mount (Part Number
CAMMOUNTPAN) to the universal visor bracket, and
then connect and adjust the forward-facing zoom camera
(Part Number SV-PRSONY-10X), as follows:
PATROLRECORDER 4C IG Ver 1.5.doc
7
Ï Connecting the Swivel Mount and Installing the Forward-
Facing Zoom Camera
Rear Camera Installation
Typically, the rear camera (Part Number SV-CFRC) is
installed in a discreet location behind the vehicle partition,
facing the rear seat.
Affix the mounting bracket, which rotates 360 degrees
and tilts 180 degrees, and install the camera in the
mounting bracket with the provided screws, as follows:
Ï Installing the Rear Camera
Wireless Audio System Installation
Typically, the bracket for the wireless audio system is
mounted on the front side of the vehicle partition. For
best wireless reception, mount the bracket as high as
possible in the vehicle cabin. In addition, do not place
wireless audio system devices near televisions,
speakers, or other electronic devices.
Affix the bracket to the vehicle surface with the supplied
screws, and then place the transmitter (Part Number
SV-PR2.4GREC) and base (Part Number
SV-PR2.4GREC) into the bracket and connect the
wireless audio system antenna, as follows:
Ï Installing the Wireless Audio System
Connecting Components
When connecting components, select inconspicuous
cable routes that do not interfere with driver or passenger
mobility and that prevent damage to the cables
Refer to Appendix A for illustrations of typical system
wiring and component connections and close-ups of the
main wiring harness (Part Number SV BHRNS) and the
monitor/inline control box cable (Part Number SV ILCB).