Riva RC6602HD-5311 Quick Installation Manual - page 3
3
www.rivatech.de
Step2. Install IP device
1) Place the installation template that is provided in the package on the
desired position of installation.
2) Drill four holes on the template and insert anchor blocks into the
holes. Fasten the camera housing with screws.
3) Make sure the cables are properly connected to the camera by
referring to the Step 1.
4) Adjust the camera to the desired angle by unscrew the joints by
referring to the following pictures.
Adjust this joint to
install it on the wall
Tiling adjustment
Panning adjustment
The
camera
may fall off the ceiling even after the proper installation and
mounting. To prevent any accident, make sure the ceiling is firm and
stable enough to support the
camera
. If any reinforcement is needed,
consult with your safety personnel and proceed with the installation.
Caution
!