Rioworks PURCA User Manual - Powering On Your Computer

Hardware Installation 

Step 6. 

Powering on Your Computer 

1.  Be sure that all switches are off (in some systems, marked with “O”).  

2.   After finishing all jumper settings  and connections, close the system case 

cover.  

3.   Connect the power supply cord into the power supply located on the back 

of your system case.  

4.   Connect the power cord into a power outlet that is equipped with a surge 

protector.  

5.   You may then turn on your devices in the following order:  

?? Your monitor  

?? External SCSI devices (starting with the last device on the 

chain)  

?? Your system power.  

For ATX power supplies, you need to switch on the power supply as well as 

press the ATX power switch on the front of the case.  

6.  The power LED on the front panel of the system case will light up. For ATX 

power supplies, the system LED will light up when the ATX power switch is 

pressed. The monitor LED may  light up after the system’s  LED  if it 

complies with “green” standards or if it has a power standby feature. The 

system will then run power-on tests. While the tests are running, additional 

messages will appear on the screen. If you do not see anything within 

30 seconds from the time you turn on the power, the system may 

have failed a power-on test.  Recheck your jumper settings and 

connections or call your retailer for assistance.  

1-20