Raritan Dominion KX III Quick Setup Manual - page 5
Dominion KX III Quick Setup Guide
5
QSG-DKX3-v3.5.0-0J-E 255-62-0003-00-RoHS
Configure KX III for Dual LAN Isolation Mode
Isolation mode allows you to access each LAN port
independently using different IP addresses.
Failover is not supported in this mode.
1. Select Device Settings > Network to open the Device
Network Settings page.
2. Set the IP Auto Configuration to
None
in the IPv4 section.
3. Ensure the "Enable Automatic Failover" checkbox is not
selected.
4. If needed, manually specify the network parameters by
entering the Default Gateway and then complete the steps
that follow.
Alternatively, if you do not want to set a static IP, see
Disable or Enable DHCP in KX III.
5. Enter the IP address you want to use to connect to the KX
III LAN1. The default IP address is 192.168.0.192.
6. Enter the IPv4 Subnet Mask. The default subnet mask is
255.255.255.0.
7. In the LAN2 IPv4 section, set the IP Auto Configuration to
None
.
8. Enter the IP address you want to use to connect to the KX
III LAN2.
9. Enter the LAN2 IPv4 Default Gateway and Subnet Mask.
10. Complete the IPv6 sections, if applicable.
11. Select the IP Auto Configuration.
If
None
is selected, you must manually specify -
Global/Unique IP Address - this is the IP address
assigned to KX III.
Prefix Length - this is the number of bits used in
the IPv6 address.
Gateway IP Address.
Select
Router Discovery
to locate a Global or Unique IPv6
address instead of a Link-Local subnet. Once located, the
address is automatically applied.
Note that the following additional, read-only information
appears in this section -
Link-Local IP Address - this address is automatically
assigned to the device. It is used for neighbor
discovery or when no routers are present.
Zone ID - Identifies the device the address is
associated with. Read-Only
12. Select "Use the Following DNS Server Addresses" and
enter the Primary DNS Server IP Address and Secondary
DNS Server IP Address. The secondary addresse is used if
the primary DNS server connection is lost due to an
outage.
Note: "Obtain DNS Server Address Automatically" and
"Preferred DHCP Host Name" are only enabled when KX
III is configured in DHCP mode
13. When finished, click OK.
Your KX III device is now accessible via the LAN1 IP
address and the LAN2 IP address.
Name Your Target Servers
Connect all of the target servers if you have not already done
so.