Raritan Dominion KX III Quick Setup Manual - page 4
Dominion KX III Quick Setup Guide
4
QSG-DKX3-v3.5.0-0J-E 255-62-0003-00-RoHS
Up to 32 alphanumeric and valid special characters, no
spaces between characters.
Next, configure the IP address and DNS settings.
Choose Failover or Isolation Mode
Configure KX III for Dual LAN Failover Mode
(on page 4)
Configure KX III for Dual LAN Isolation Mode
(on page 5)
Configure KX III for Dual LAN Failover Mode
LAN1 and LAN2 share the same IP address to support
automatic failover.
LAN1 is the primary port. If LAN1 fails, LAN2 is used to access
KX III.
1. Select Device Settings > Network to open the Device
Network Settings page.
2. Set the IP Auto Configuration to
None
in the IPv4 section.
3. Select the "Enable Automatic Failover" checkbox under
LAN Interface Settings to enable failover.
4. Manually specify the network parameters by entering the
Default Gateway.
5. Enter the IPv4 IP Address, if needed. The default IP
address is 192.168.0.192.
6. Enter the IPv4 Subnet Mask. The default subnet mask is
255.255.255.0.
7. The LAN1 settings are applied to LAN2 if failover occurs.
8. Complete the IPv6 sections, if applicable.
9. Select the IP Auto Configuration.
If
None
is selected, you must manually specify -
Global/Unique IP Address - this is the IP address
assigned to KX III.
Prefix Length - this is the number of bits used in
the IPv6 address.
Gateway IP Address.
Select
Router Discovery
to locate a Global or Unique IPv6
address instead of a Link-Local subnet. Once located, the
address is automatically applied.
Note that the following additional, read-only information
appears in this section -
Link-Local IP Address - this address is automatically
assigned to the device. It is used for neighbor
discovery or when no routers are present.
Zone ID - Identifies the device the address is
associated with. Read-Only
10. Next, select "Use the Following DNS Server Addresses"
and enter the Primary DNS Server IP Address and
Secondary DNS Server IP Address. The secondary address
is used if the primary DNS server connection is lost due to
an outage.
Note: "Obtain DNS Server Address Automatically" and
"Preferred DHCP Host Name" are only enabled when KX
III is configured in DHCP mode
11. When finished, click OK. Your KX III device is now network
accessible.