NEC SV8500 Operation And Maintenance Manual - Flinst: File Install
– 858 –
CHAPTER 7
Maintenance Commands
FLINST: File Install
1. Functional Outline
This command is used to install the DPSW-dedicated database files to your PCPro. This command is necessary
to provide each circuit card’s various information (such as circuit card name, equipped switch names, etc.) when
your system uses the DPSW/DPKG command.
2. Parameters
Input Data
None
Buttons
Copy:Start the data file install.
Exit:Exit this command.
(1) Start up the FLINST command from the Start menu.
(2) Initial Display of the FLINST command appears. Make sure the proper Floppy Disk Drive (FDD) name is
selected in the FDD parameter.
(3) Click the Copy button. A message appears, indicating insert FD into the FDD.
(4) Insert the FD into the FDD of the PCPro. Click OK.
(5) File copy starts automatically. The Copy End message appears upon completion.
(6) Click OK. Another message asks whether the next FD is to be installed or not.
(7) Click OK.
(8) A message, requiring insertion of another FD into the FDD drive is displayed. Insert the FD into the FDD,
and click OK.
(9) File copy starts automatically. The Copy End message appears upon completion.
(10) Click OK. A message asks whether the next (fourth) FD is to be installed.
(11) Click Cancel.