NEC SV8500 Operation And Maintenance Manual - page 824
– 777 –
CHAPTER 7
Maintenance Commands
DCBD: Display of Call Block Entry Data
1. Functional Outline
This command is used to display the following Call Block data, assigned to a station:
•
Number of station/trunk whose call is to be blocked (in the remainder of this page, denoted as Restriction
Number)
•
Registered Restriction Numbers in total
Data can be obtained by entering any of the station’s telephone number (TYPE 1), physical station number
(TYPE 2) or LENS (TYPE 3) in the parameters below:
2. Parameters
Input Data
TYPE:Selection of Input Data Type
TYPE 1 (Input Data = UGN, TELN)
TYPE 2 (Input Data = FPC, TN, STN)
TYPE 3 (Input Data = FPC, LENS)
READ (button to view the Display Data)
EXIT (button to exit)
Note:
When using this command, first choose the input data type (TYPE 1 - 3) in TYPE selection list box. Then
the following parameters appear, according to the selected data type.
•
When TYPE 1 is selected
: User Group Number [UGN]
Telephone Number [TELN (maximum 16 digits)]
•
When TYPE 2 is selected
: Fusion Point Code [FPC (1-253)]
Tenant Number [TN (maximum three digits)]
Physical Station Number [STN (maximum six digits)]
•
When TYPE 3 is selected
: Fusion Point Code [FPC (1-253)]
Line Equipment Number [LENS]