Lanzar VCTBS10 Owner's Manual - page 3
Rear panel controls and features
FUSES
CDLOW LEVEL R CA INPUTS
POWER
€11
Low level inputs are the recommended way to introduce the audio signal
to the subwoofer if RCA outputs are present on your head unit or other
signal source (such as a sound processor).
@HIGH LEVEL
(
sp
e
a
k
e
r
level}
INPUTS
If your head unit does not have RCA outputs , you can use the speaker
outputs for the audio source for the VCTBS10. Use the supplied cable
and connect the outputs properly as shown in the connection diagram
in this manual .
@FUSE
The fuse is rated at 20A . Do not use a fuse with a different value and
NEVER replace the fuse with a wire or coin.
®POWER T ERMINALS
VCTBS10 Owner's Manual-4
Low Level
Input Wiring
Low-level (RCA) input wiring is preferred for best audio performance. Most
trunk or hatchback installations will require a 15-20 foot RCA cable, while
pickup trucks and under-seat installations will require a 6-12 foot RCA cable.
Always use a high-quality cable.
NOTE:
Do not connect
BOTH
the high level and low level inputs
from your receiver to your amplifier at the same time!
H igh
Level
Input Wiring
€11
FUSES
POWER
c€llc
€11
(tit>()))
+llV REMOTE 'ROUNP
To Audio
Outuputs of head
unit or signal
processor
The high level input(s) should only be used when your receiver lacks RCA
outputs. If the RCA outputs are not present, connect the speaker outputs from
the receiver to the high level input connector of the amplifier. Be sure to
observe polarity to avoid audio phase problems.
NOTE:
Do not connect
BOTH
the high level and low level inputs
from your receiver to your amplifier at the same time!
INPllTt LINE UVEl
.....
l
R
WH/TE1+
BLUE 1-
POWER
€11
2+GREEN
2-PURPLE
TO Speaker Terminals
of
head unit
5-VCTBS10 Owner's Manual