Kemppi 350 Operating Manual - page 21
EN
8.
Choose and SELECT shielding Gas – Press SELECT button
9.
Choose and SELECT curve – Press SELECT button. (Note: The curve(s) presented in this
view are based on your previous selections from items 4 through to 8.)
10. Choose and SAVE memory channel number. Memory channel selections are made using
either the White +/- buttons OR Orange UP-DOWN buttons – Press SAVE button
READY TO WELD: Your basic welding selection and set-up is now complete. You are ready to
weld, providing you select the corresponding channel ‘Job’ number on the PF65 wire feed unit
panel. Set your welding power and arc length and weld.
NOTE!
If you SELECT ‘MIG’ (i.e. Basic MIG/MAG selection in the above listing) you will automatically
jump from item 4 to item 9. When you have saved your channel ‘Job’ number selection, you will
have access to basic MIG/MAG welding on this channel. Voltage and wire feed speed are then
selected in the normal way.
Memory ‘Job’ Channels and user Channels
1.
There are 10 x separate MEMORY ‘JOB’ CHANNELS per Active USER channel.
2.
There are 10 x USER channel choices.
So there is a maximum of 100 x channels available for a variety of welding ‘Job’s, welding
projects or multi-operator environments.
Welding parameters can be quickly saved to MEMORY ‘Job’ CHANNEL Numbers and recalled
later or updated later unless ‘locked’ via the four digits ADMINISTRATOR PIN code lock.
USER channels can be activated through either the MAIN MENU or fast function Key F2,
marked USER. Selection process is then standard. SELECT USER number, and use pre recorded
channel information OR save and record new channel information.
P65 – Fast Function keys
The fast function keys, F1, F2 and F3 are short cut keys.
• F1 CHANNEL INFO – Display the basic data recorded to the displayed channel.
• F2 USER – Displays the ‘Active’ User and allows a new User channel activation.
• F3 WF# – Displays active and selected wire feed unit and allows a new WFU selection.
FastMig Pulse allows up to 7 x wire feed units to be connected to one power source.
NOTE!
Only one wire feed unit can be active at any one time and must be selected before it will
operate.
19
FastM
ig P
ulse 350, 450 / © Kemppi O
y / 1110