Kemppi 350 Operating Manual - page 18
EN
adMinistratOr Menu
(In Main menu 2/7, User Identification)
Change PIN Code
Administrator pin code
change.
Factory PIN code: 0000
Ask PIN
PIN code inquiry selection:
OFF / StartUp / Menu
Factory Setting: OFF
OFF: No PIN code inquiry.
StartUp: Setup panel (P65) always asks for
the PIN code when the machine is turned
on. PF 65 is not affected and always works
without PIN.
Menu: Setup panel (P65) asks every
time for PIN code when MENU button is
pressed and when the display is in channel
info mode i.e. in start-up view. PIN code
inquiry is made only once when entering
the menu. After that the menu button can
be pressed any time without PIN inquiry.
ButtOn FunCtiOns
ON / OFF Button
Short Press: Panel returns to default start-up display view (Channel info display).
Long Press: When setup panel (P65) is ON => Setup panel and all PF65 panels are turned OFF. When
setup panel is OFF => Setup panel and all PF65 panels are turned ON.
Pressed while machine is turning ON: Restore to factory shortcut. Panel will ask confirmation to
restore factory setting.
If Setup panel is OFF and some other PF65 panel is turned ON the Setup Panel turns also ON and will
be linked automatically to this PF panel (WF# function).
F1 Button
F1 button gives further information of selected memory channel.
Pressed while machine is turned ON: Restore language selection to English.
F2 Button
F2 button can be used to select user.
Selections: 1 – 10, Administrator.
If Welding Process is MMA only Administrator is allowed.
F3 Button (WF#)
F3 button can be used to select Wire Feeder.
Panel allows selecting only those WF numbers that are found connected on the sys-tem.
Channel +/-
Memory channel selection.
Up/Down Button
Moving Up/Down in menu.
Right/Left
selection buttons
(Soft Keys)
Button function depends on where in menu you are.
16
FastM
ig P
ulse 350, 450 / © Kemppi O
y / 1110