Kawasaki KX250F - Owner's Manual - page 78
77
j
•
Apply molybdenum disulfide grease to the steel
ball and the contact area of the push rod holder.
•
Install the steel ball and the push rod holder.
A. Apply molybdenum disulfide grease.
B. Push Rod Holder
C. Steel Ball
•
Install the clutch pressure plate and springs.
•
Tighten the clutch spring bolts to the specified
torque.
Tightening Torque
Clutch Spring Bolts:
9.0 N·m (0.92 kgf·m, 80 in·lb)
•
Check the release shaft lever position by measur-
ing the position distance between the lever and the
cable bracket while pushing the release shaft lever
lightly forward.
A. Release Shaft Lever
B. Push forward.
C. Position Distance
D. Cable Bracket
Position Distance
Standard
49.2
∼
56.5 mm (1.94
∼
2.22 in.)
•
If the lever position is not within the standard, se-
lect the correct thickness of adjusting washer ac-
cording to the following table.
•
Remove the push rod holder as necessary and
reinstall the clutch.