Vehicle dock kit installation instructions.
Ii vehicle dock kit installation instructions intermec technologies corporation worldwide headquarters 6001 36th ave.W. Everett, wa 98203 u.S.A. Www.Intermec.Com the information contained herein is provided solely for the purpose of allowing customers to operate and service intermec-manufactured equ...
Vehicle dock kit installation instructions iii document change record this page records changes to this document. This document was originally released as revision a. Revision letter date description of change c 03/2007 added pin-out information for the 3-pin notched dc power connector. Rewrote inst...
Iv vehicle dock kit installation instructions.
Vehicle dock kit installation instructions v contents installation guidelines . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7 vehicle electrical considerations. . . . . . . . . . . . . . . . . . . . . .7 installing the vehicle battery power cable . . . . . . . . . . . . . .8 connecting to...
Vi vehicle dock kit installation instructions.
Vehicle dock kit installation instructions 7 installation guidelines these instructions detail tasks for various installation options. Your tasks include: • route and install the gray battery power cable to the vehicle battery terminals • install an in-line fuse holder • install the mounting hardwar...
8 vehicle dock kit installation instructions installing the vehicle battery power cable use cable clamps or wire-ties at least every 46 cm (18 in) when installing cables on a vehicle. This eliminates loose or sagging cables, guards against breakage and ensures that they do not pose a hazard to the v...
Vehicle dock kit installation instructions 9 connecting to the side battery terminal 1 remove both battery terminal side post bolts from the vehicle battery. 2 screw a 3/8" nut as far as it will go onto a 3/8" x 1 1/2" post furnished in kit. 3 slip a 3/8" washer onto the battery terminal post. 4 sli...
10 vehicle dock kit installation instructions repeat steps 2 through 8 for the negative (brown) wire from the battery cable, hooking up the negative cables to the negative (-) battery terminal. Connecting to the top battery terminal 1 remove the battery clamp posts from the vehicle battery terminals...
Vehicle dock kit installation instructions 11 repeat steps 3 through 6 for the negative (brown) wire from the battery cable, connecting the wire to the negative (-) battery terminal. Fastening the ground strap the white connector on the battery power cable has a braided green wire grounding strap th...
12 vehicle dock kit installation instructions verifying the dock power cable polarity below are the pin descriptions for the notched dc power connector on the dock power cable. Use a volt meter to verify whether +12 volts is on pin 2 before you make the final cable connection. Vehicle dock power cab...
Vehicle dock kit installation instructions 13 installing an optional printer if you are adding a printer to your system, you need the power cables to connect the printer and vehicle dock to the vehicle battery. You must place a separate order for a remote terminal cable: • db 9-pin to db 25-pin cabl...
14 vehicle dock kit installation instructions for installation in a system that includes a printer refer the following wiring diagram. Installing the vehicle dock and printer 1 install a printer-specific “y” power cable to supply power to both the vehicle dock and to the printer. 2 connect one end o...
Vehicle dock kit installation instructions 15 to modify the black dock cable to connect into a vehicle fuse block • switch to using the fuse block cable p/n 226-109-003, or cut off the white connector from the end of the dock power cable and wire it directly to the fuse block. Jump-starting your veh...
Worldwide headquarters 6001 36th avenue west everett, washington 98203 u.S.A. Tel 425.348.2600 fax 425.355.9551 www.Intermec.Com vehicle dock kit installation instructions *962-000-021c* p/n 962-000-021c.
