Interlogix TVB-5301 Installation Manual - page 46
40
Installation Guide
3. Route the cables through the center of the adapter plate
and connect the appropriate cables inside the electrical
box.
4. Attach the dome to the adapter plate.
5. Connect the video output connector to the monitor.
Connect the power connector to the power supply.
6. Adjust the image and focus.
a) Three-axis adjustment.
View the camera image using the monitor. Rotate
the lens assembly (see image below) to adjust the
panning position of the camera. Move the assembly
up and down to adjust the tilt position of the camera.
Rotate the inner lens assembly to obtain the desired
surveillance angle.
b) Zoom and focus adjustment.
Loosen the zoom lever and move the lever between
T(Tele) and W(Wide) to obtain the appropriate angle
of view.
c) Tighten the zoom lever.
Loosen the focus lever and move the lever between
F(Far) and N(Near) to obtain the optimum focus.
Tighten the focus lever.