Interlogix TVB-5301 Configuration Manual - Tamper-Proof Alarms
40
TruVision Series 3 IP Camera FW3.1 Configuration Manual
Trigger Alarm Output
Trigger external alarm outputs when an event occurs.
Note: This option is only supported by cameras that support an
alarm output.
12. Click
Save
to save changes.
Tamper-proof alarms
You can configure the camera to trigger an alarm when the lens is covered and
to take an alarm response action.
To set up tamper-proof alarms:
1. Click
Configuration > Basic Event
>
Tamper-proof
.
2. Check the Enable Tamper-proof box.
3. Move the
Sensitivity
slider to set the sensitivity of the detection.
All areas will have the same sensitivity level.
4. Click
Edit
to edit the arming schedule for tamper-proof alarms. The arming
schedule configuration is the same as that for motion detection. See “To set
up motion detection” for more information.
5. Check the check box to select the linkage method taken for the tamper-proof.
6. Click
Save
to save changes.
Exception alarms
You can set up the camera to notify you when irregular events occur and how
you should be notified. These exception alarms include:
• HDD Full: All recording space of NAS is full.
• HDD Error: Errors occurred while files were being written to the storage, no
storage or storage had failed to initialize.