Interlogix TVB-5301 Configuration Manual - page 41
TruVision Series 3 IP Camera FW3.1 Configuration Manual
39
To set up motion detection in advanced mode:
1. Click
Configuration > Basic Event
>
Motion Detection
.
2. Check the
Enable Motion Detection
box. Check
Enable Dynamic Analysis
for Motion
if you want to see where has motion real-time.
Note:
Select Disable for rules in local configuration menu if you don’t want the
detected objected displayed with the rectangles.
3. Select
Advanced
mode from the drop down menu.
4. Select OFF, Auto-switch or Scheduled-switch
5. Select
Area No.
and click
Draw Area
. Click and drag the mouse on the live
video image to draw an area sensitive to motion detection.
6. Click
Stop Drawing
to finish drawing. Click
Clear All
to delete all areas
marked and restart drawing.
7. Move the
Sensitivity
and
Proportion of Object on Area
slider to set the
sensitivity and proportion of the detection for different areas
8. Click
Edit
to edit the arming schedule. See the picture below for the editing
interface of the arming schedule.
9. Choose the day and click
to set the detailed time period. You can copy the
schedule to other days.
10. Click
OK
to save changes.
11. Specify the linkage method when an event occurs. Check one or more
response methods for the system when a motion detection alarm is triggered.
Notify Alarm Recipient
Send an exception or alarm signal to remote management
software when an event occurs.
Send Email
Sends an email to a specified address when there is a motion
detection alarm.
Upload Snapshot
Capture the image when an alarm is triggered and upload the
picture to NAS or FTP server.
Trigger Channel
Triggers the recording to start in the camera.