HoMedics UHE-CM55 Cool Mist Instruction Manual - page 4
6
7
Fig. 2
How To Use
Power Button
Plug unit into a 120 volt AC electrical outlet. Press the POWER BUTTON ( ) once to turn the
humidifier on.
ATTENTION:
When the water in the tank is almost empty, the humidifying function will power off to
indicate to the user to refill the tank.
Dual Swivel Mist Spout
This unit has a dual swivel mist spout that allows you to direct the mist 360°. Simply adjust the outlets
to aim the mist in whichever direction you want.
Mist Adjustment Setting
Mist adjusts from MINIMUM ( 1 ) mist to MAXIMUM ( 3 ) mist. To increase the mist output, press the
MIST button. To decrease mist output, cycle through all three mist settings.
Night Mode
Press the TIMER ( ) button for three seconds to turn off all display LED's. To turn night mode off,
and control lights on, press and hold TIMER ( ) button for three seconds.
Programmable Humidistat
This unit has a programmable humidistat that can be set in 5% increments from 35% - 60% humidity.
To program the humidity level, press the HUMIDISTAT button and cycle through selections. After
selection is made display will revert to showing existing RH%. After 60% screen will display "--" and
clear the program. Once the programmed humidity level is reached, the unit will stop misting until the
humidity level drops below the programmed level. Then it will resume misting.
Timer
The timer will cycle through the following settings: 1 hour, 2 hours, 4 hours, 6 hours, 8 hours, 9 hours,
and "0". Press the TIMER button to activate the timer. The timer setting indicator will read "1". To select
the desired timer setting, keep pressing the TIMER button until the desired timer setting is lit. To turn
the timer off, press the TIMER button until "0" is displayed, after 2 seconds the timer will turn off.
Programmable
Humidistat
Timer
Power
ON/OFF
Mist
Adjust
Using the Remote Control
BEFORE FIRST USE, REMOVE PLASTIC PULL TAB FROM BATTERY COMPARTMENT.
Battery Installation
One CR2025 3V battery is included with the remote control. To change the battery,
remove the battery door at the back of the remote by squeezing the tab and pulling the
door away from the back of the remote. Please insert the battery into the remote with the
positive side up as shown on the drawer.
NOTE: Always keep the battery and remote control out of the reach of children.
BATTERY NOTE
• If the unit is not going to be used for a long period of time, remove batteries to
prevent damage due to possible battery leakage.
• Clean the battery contacts and also those of the device prior to battery installation.
• Remove used batteries promptly.
• Dispose of properly in accordance with all state, province, and country regulations.
• Do not dispose of batteries in fire. Batteries may explode or leak.
• Use only the size and type of batteries specified.
• When installing batteries, observe proper polarity +/-. Improper installation of
batteries may cause damage.
Power ON/OFF
Timer
Mist Level
Humidistat
Night Mode
ON/OFF