Garland HEEG “CL” Installation and operation manual - page 4
Part # 4526671 (10/02/09)
Page 4
DIMENSIONS AND SPECIFICATIONS CL MODELS
3-1/8"
[79mm]
3/4" NPT
GAS INLET
2"
[51mm]
ELECTRICAL
23-1/2"
[596mm]
"A"
"B"
"C"
18-1/16"
[458mm]
HEEG-48CL BROILER SHOWN
"E"
14-3/4"
[375mm]
28-13/16"
[732mm]
7/8"[22mm]
2-1/16"
[53mm]
ELECTRICAL
13/16"
[21mm]
3/4"
GAS INLET
7-1/8"
[185mm]
4-7/8"
[123mm]
"D"
Model #
Dimensions: In. (mm)
No. Of
Burners
Total BTU*
Shipping
Width
Depth
Height
Natural
Weight Lbs/Kg
HEEG-24CL 24 (610)
38-1/16 (967) 18-1/16 (458)
4
54,000
338/153
HEEG-36CL 34 (864)
38-1/16 (967) 18-1/16( 458)
6
81,000
391/177
HEEG-48CL 48 (1219)
38-1/16(967)
18-1/16 (458)
9
121,500
505/229
HEEG-60CL
58 (1473)
38-1/16 (967)
18-1/16 (458)
11
148,500
620/281
* Manifold operating pressure as per table shown below
Gas Manifold 3/4" NPT on all models
Gas Input ratings shown here are for installations up to 2000 ft . (610m)
Models
Manifold Operating
Pressure
Minimum Supply Pressure
Natural Gas
Natural Gas
"w .c .(Mbar)
"w .c .(Mbar)
All Models
4 .5 (11 .2)
7 .0(17 .4)
Depth Measurements all models In (mm)
Front Rail Option
Over All "A"
Rail "B"
With/ 1/3 Pan Cutouts 38-1/16 (967) 8-7/8 (225)
With/1/9 Pan Cutouts
35-5/8 (905)
6-3/8 (162)
Std . Rail (No Cutouts)
34-5/8 (879)
5-3/8 (137)
Stub Rail (No Cutouts) 31-3/4 (806)
2-1/2 (64)
Width Measurements In (mm)
Model
Broiler Grid
"C"
"D"
Over All
"E"
HEEG-24CL
20 (507)
14-1/4 (362)
24 (610)
HEEG-36CL
30 (761)
24-1/4 (616)
34 (864)
HEEG-48CL
44 (1117)
36-1/4 (972)
48 (1219)
HEEG-60CL
54 (1371)
48-1/4 (1226)
58 (1473)
Electrical : 120V, 60 Hz
Provided with NEMA 5-15P Power Cord Supply
NOTE: Wiring Diagram is located in right side of broiler’s
leg section .
Garland/U .S . Range products are not approved or authorized
for home or residential use, but are intended for commercial
applications only . Garland / U .S . Range will not provide service,
warranty, maintenance, or support of any kind other than in
commercial applications .
Many local codes exist and it is the responsibility of the
owner and installer to comply with those codes .