Garland 40 Series Technical Reference Manual - page 100
Other manuals for 40 Series:
Service Manual
of
108
Part # GCTRM Rev 3 (12/10/09)
Page 100
To adjust the pilot size, turn the
No adjustment should be made
pilot adjustment screw (A). The
to the screw circled above.
pilot flame should be approximately
Please see notes*
¾ of an inch long.
To shut down all gas to pilots and
burners, loosen the knob set screw
and gently pull knob off and proceed
to figure 8.
With the knob removed, turn the hub
until the metal tab (B) lines up with
the * symbol (A). With the hub in the
position shown, the gas should be off
at the pilots and burners. When ready
to relight the pilot, turn the hub to the
position shown in figure one and push
in to light.
6
5
A
8
7
A
B