Fargo C50 Service Manual - page 39
C50 Card Printer Service Manual PLT-01278 rev 1.1
August 2013
Page 39
HID GLOBAL CONFIDENTIAL AND/OR PROPRIETARY INFORMATION. This document contains confidential and/or proprietary information,
which may not be duplicated, published, disseminated or disclosed, or used for any purpose, without the written consent of HID Global
Corporation. If you are an unintended recipient of this information or are unwilling to accept the above restrictions, please immediately return
this document to HID Global Corporation, 15370 Barranca Pkwy, Irvine, CA 92618-3106..
Step Procedure
3
Remove the Damper Cap (F000487)
Use a thin flathead screwdriver to loosen one side.
The cap will pop off.
Note: Replace the Damper Cap by lining up the shaft first then snap the Damper Cap back
on.
Verify the gray shaft is pushed up to hold the encoder wheel in place.