Fargo C50 Service Manual - page 19
C50 Card Printer Service Manual PLT-01278 rev 1.1
August 2013
Page 19
HID GLOBAL CONFIDENTIAL AND/OR PROPRIETARY INFORMATION. This document contains confidential and/or proprietary information,
which may not be duplicated, published, disseminated or disclosed, or used for any purpose, without the written consent of HID Global
Corporation. If you are an unintended recipient of this information or are unwilling to accept the above restrictions, please immediately return
this document to HID Global Corporation, 15370 Barranca Pkwy, Irvine, CA 92618-3106..
3.3
Remove/Replace the Mag Roller (D930122)
Step Procedure
1
Caution: Turn OFF the Printer and unplug the power cord from the Printer.
2
Remove the Stepper Motor Assembly (D930028)
Remove the 3 screws that hold the Motor/Mount to the printer frame. (Make note of where
the 2 screw/washers go and the one machine screw. Remove the Printhead cable for more
clearance.)
The motor is attached to a plastic mounting frame.
Located: Rear Sideplate (D930068)
Tools needed: Small flat screwdriver, T10 Torx
screwdriver
Estimated Repair Time: 20 min
Preparation: Remove the Covers
Important: This procedure can only be performed by
authorized service personnel.