Chauvet Legend 300E Spot Quick Reference Manual - page 7
Legend 300E Spot QRG
Page 10
Continued from previous page
MODE 1
(Cont.)
Channel Function
Value
Percent/Setting
8
Color
(Cont.)
064
127
128
189
190
193
194
255
Color Mix
Fast~Slow CW rotation
Stop
Slow~Fast CCW rotation
9 Cyan
000
255 0~100%
10 Magenta
000
255 0~100%
11 Yellow
000
255 0~100%
12
Gobo 1
000
007
008
014
015
021
022
028
029
035
036
042
043
049
050
057
058
067
068
077
078
087
088
097
098
107
108
117
118
127
128
189
190
193
194
255
Open
Gobo 1
Gobo 2
Gobo 3
Gobo 4
Gobo 5
Gobo 6
Gobo 7
Gobo 1 Shaking
Gobo 2 Shaking
Gobo 3 Shaking
Gobo 4 Shaking
Gobo 5 Shaking
Gobo 6 Shaking
Gobo 7 Shaking
Fast~Slow CW rotation
Stop
Slow~Fast CCW rotation
13
R-Gobo 1
000
127
128
189
190
193
194
255
Index
Fast~Slow CW rotation
Stop
Slow~Fast CCW rotation
14
Gobo 2
000
005
006
010
011
015
016
020
021
026
027
031
032
036
037
041
042
047
048
057
058
067
068
077
078
087
088
097
098
107
108
117
118
127
128
189
190
193
194
255
Open
Gobo 8
Gobo 9
Gobo 10
Gobo 11
Gobo 12
Gobo 13
Gobo 14
Gobo 15
Gobo 8 Shaking
Gobo 9 Shaking
Gobo 10 Shaking
Gobo 11 Shaking
Gobo 12 Shaking
Gobo 13 Shaking
Gobo 14 Shaking
Gobo 15 Shaking
Fast~Slow CW rotation
Stop
Slow~Fast CCW rotation
Continues on the next page
Legend 300E Spot QRG
Page 7
Replacing
the Lamp
1) Turn the fixture off and disconnect it from the power outlet.
2) Wait at least 15 minutes for the lamp to cool down.
3) Loosen the two screws on the lamp cover (marked “A” in the diagram).
4) Lift and rotate the lamp cover as per the diagram to expose the base of
the lamp.
5) Rotate the ceramic base of the lamp 90º counterclockwise.
6) Pull the lamp out by holding it from its base only.
7) Insert the new lamp and turn it 90º clockwise.
8) Reverse steps 3 and 4.
9) Use the adjustment screws (marked “B” in the diagram) to position the
lamp in the center of the reflector to obtain the best output.
Increasing the
Lamp’s Life
ALWAYS turn the lamp off by using the DMX controller or the
fixture’s control panel. Then wait at least five minutes before switching
off the fixture. This will keep the fans running to extract any remaining
heat from the fixture’s head.
DO NOT power cycle the fixture unless it is necessary.
DO NOT touch the lamp without wearing gloves to avoid leaving
grease on the bulb or on the contacts that could reduce the lamp’s life.
ALWAYS change the lamp when it has reached its recommended
lifespan to avoid the risk of lamp explosion.