Chauvet Legend 300E Spot Quick Reference Manual - page 6
Legend 300E Spot QRG
Page 6
Replacing a
Gobo
1) Turn the fixture off and disconnect it from the power outlet.
2) Open the head cover by loosening the four fastening screws at the sides
of the top cover.
3) Separate the gobo plate away from Gobo Wheel 1 by pushing it toward
the front of the moving head (direction 1 in the diagram). Be careful not
to push the gobo out of the gobo plate.
4) Extract the gobo plate l by pulling it outward (direction 2 in the
diagram).
5) On a flat surface, remove the expansion ring that holds the gobo in
place and remove the gobo from the gobo plate.
6) Insert a new gobo and hold it in place with the expansion ring.
7) Slide the tip of the gobo plate under the pressure plate near the center of
Gobo Wheel 1.
8) Push the gobo plate inwards. DO NOT force the gobo plate into the
gobo wheel slot. If correctly installed, the gobo plate should
accommodate itself in the gobo wheel slot.
Legend 300E Spot QRG
Page 11
Continued from previous page
MODE 1
(Cont.)
Channel Function
Value
Percent/Setting
15
Focus
000
255 Near~Far
16
Zoom
000
255 0~100%
17
Prism
000
008
009
255
Normal
Prism effect
18
R-Prism
000
127
128
189
190
193
194
255
Index
Fast~Slow CW rotation
Stop
Slow~Fast CCW rotation
19
Iris
000
255 0~100%
20
Frost
000
255 0~100%
21
Function
000
069
070
079
080
089
090
099
100
109
110
119
120
129
130
139
140
149
150
159
160
169
170
179
180
189
190
199
200
209
210
229
230
239
240
249
250
255
No function
Enable BO during Pan or Tilt
Disable BO during Pan or Tilt
Enable BO during color change
Disable BO during color change
Enable BO during gobo change
Disable BO during gobo change
Lamp on
Pan / Tilt reset
Color / CMY reset
Gobo 1 / Gobo 2 reset
Shutter reset
Focus / zoom. / prism / frost reset
Iris / flatb reset
Reset all
No function
Lamp off
Enable flatb
Disable flatb
End of Mode 1