Chauvet COLORado 1 User Manual - page 13
U P L O A D C U S T O M P R O G R A M S T O A N O T H E R F I X T U R E :
1)
On all fixtures that are going to receive the custom programs from the source unit, set them for
DMX operation; address does not matter for the purpose of this operation.
2)
On the Master unit, press until “SET” is displayed, and press .
3)
Scroll through until “UPLd” is displayed, and press .
4)
“PASS” will now be displayed. Press , and the display will go blank, except for a single
dot.
5)
Press , then , then , then , then . This is the same
password that is used for the main access password.
6)
“SENd” will now be displayed, and all units will output the color yellow.
7)
When the upload is complete, the sending fixture will display “ENd”, and all fixtures will output
the color green to indicate a successful upload. If a unit has an error, it will output the color red.
8)
Press on the source unit to exit the upload mode.
A C T I V A T E O R D E A C T I V A T E T H E P A S S W O R D :
1)
Press until “PASS” is displayed, and press .
2)
Select “OFF” or “ON” and press .
Note:
The password is permanently set as , , , ; this cannot be
changed.
Service Functions
R E S E T C U S T O M P R O G R A M S T O F A C T O R Y D E F A U L T S
1)
Press until “SET” is displayed, and press .
2)
Scroll through until “REST” is displayed, and press .
3)
“PASS” will now be displayed. Press , and the display will go blank, except for a single
dot.
4)
Press , then , then , then , then . This is the same
password that is used for the main access password.
5)
“REST” will now be displayed, and will be flickering. After about 30 seconds, the reset sequence
will be complete, and “REST” will be displayed without flickering.
6)
Press to exit the reset mode.
Operation
Stand-Alone Mode (Auto Mode):
This mode allows a single unit to auto change in Auto Mode.
1)
Press until “Auto” appears on the display, and press .
2)
Press scroll through to the desired program (either Auto 1-10 or Custom 1-10), and press
to select it. The unit will now auto change in Auto Mode.
COLORado 1 User Manual
13
2008-01-18/16:45