Bissell 1315 SERIES User Manual - page 8
www.BISSELL.ca
Mainte nan ce & Care
Brush roll maintenance
The brush roll may accumulate debris such as
strings, hair and fibers. This type of debris can
wrap around the brush and diminish its ability
to clean effectively.
To remove brush roll for cleaning:
1. Turn power OFF. Turn unit over to access the
brush roll.
2. Slide down the lock tab and pull up the brush
roll gate.
3. To remove brush roll, simply lift the brush out
of the brush chamber. Clean off hair or other
debris from brush roll.
4. Place cleaned brush roll back into foot of unit
by aligning the brush roll end to the brush driver.
5. Lock the brush roll in place by closing the
brush chamber gate and sliding the locking
tab in place.
Brush roll reset:
If larger debris becomes lodged in the foot
of the unit and the brush roll shuts off, turn
the unit off and remove the obstruction. Wait
approximately 15 seconds for the motor to cool
down before turning back on. Brush will function
again after allowing time to cool down.
8
2.
1.
3.