Audio Analogue Crescendo Owner's Manual - page 19
19
TROUBLESHOOTING
Symptom
Cause
Remedy
The unit is in STANDBY mode
Press the STANDBY button on the front
panel of the unit or the STANDBY button
on the remote controller
Incorrectly plugged power cord
Make sure the power cord is correctly
plugged into the wall outlet
Display is off
No sound
No response from the unit
Burned-out fuses
Contact your Audio Analogue retailer for
fuse check/replacement
Faulty or incorrectly plugged connectors
between Crescendo
tuner/usbdac and the amplifier
Check cables and their connection
Display is on
No sound
Incorrectly selected source on the amplifier
Check that Crescendo
tuner/usbdac is correctly selected
through the amplifier input
The unit is on but there is no sound
The unit is in “Storage” mode
Complete storage procedure by pressing
the STORE button on the front panel or on
the remote controller
It is impossible to tune in a radio station
Faulty or incorrectly plugged antennas.
Check that the antennas are correctly
plugged and placed (FM antenna has to
be unrolled as much as possible). Try
replacing both the antennas.
Crescendo tuner/usbdac
works but the display is off
Faulty or incorrectly plugged front panel.
Contact your Audio Analogue retailer for
connections check and front panel
replacement
No battery/ worn-out battery
Place/replace battery (2 ‘AAA’ batteries)
Remote controller doesn’t work
You’re standing too far or on an exceeding
angle from the front panel
Get closer to the unit or reduce angle
If the suggested remedies should not work or the problem is not shown in the list above, please contact your local Audio
Analogue retailer.