Summary of CAP224
Page 1
Cap series user manual www.Audac.Eu.
Page 2
2.
Page 3: Index
3 index introduction 5 cap series block diagram 6 precautions 7 safety requirements 7 caution servicing 7 ec declaration of conformity 7 waste of electrical and electronic equipment (weee) 8 caution 8 chapter 1: pin connections and connectors 9 connection standards 9 wire up the system 9 chapter 2: ...
Page 4
4.
Page 5: Introduction
5 introduction multi channel 100v power amplifiers the cap series are professional 100v multi-channel power amplifiers, containing various models with different channels and different output power configuration. Different output configurations with two and four channels and power ratings for 120 wat...
Page 6: Cap Series Block Diagram
6 cap series block diagram.
Page 7: Precautions
7 precautions read following instructions for your own safety always keep these instructions. Never throw them away always handle this unit with care heed all warnings follow all instructions never expose this equipment to rain, moisture, any dripping or splashing liquid. And never place an object f...
Page 8
8 caution the symbols shown are internationally recognized symbols that warn about potentional hazards of electrical products. The lightning flash with arrowpoint in an equilateral triangle means that the unit contains dangerous voltages. The exclamation point in an equilateral triangle indicates th...
Page 9: Chapter 1
9 chapter 1 pin connections and connectors connection standards the in- and output connections for audac audio equipment are performed corresponding to international wiring standards for professional audio equipment. Cinch (rca): for unbalanced line input connections tip: signal sleeve: ground white...
Page 10: Chapter 2
10 chapter 2 front & rear panel front panel description the front panel of the cap series slighly varies depending of the output configuration and power rating, but basically the panel layout for all cap amplifiers is similar. Power switch a power switch allows to switch the amplifier on and off, wh...
Page 11: Rear Panel Overview
11 rear panel overview rear panel description the rear panel of the cap series slightly varies depending of the output configuration and power rating, but basically the panel layout for all cap amplifiers is similar. An xlr input connector with xlr link-through output connector, a high pass filter s...
Page 12: Chapter 3
12 chapter 3 connecting the amplifier note make sure the power is swiched off when any change is made to the connections of the amplifier. Input connections the input connections of the amplifier are performed using balanced xlr connectors. Every channel has a xlr input connector and a xlr link outp...
Page 13
13 the table below shows the output voltage, impedance and maximum power load for each corresponding amplifier. Output voltage impedance power cap224 cap248 cap424 cap448 100 volt 100 volt 100 volt 100 volt 42 ohm 21 ohm 42 ohm 21 ohm 240 watt 480 watt 240 watt 480 watt the 100 volt speakers may be ...
Page 14: Chapter 4
14 chapter 4 additional information technical specifications output power cap224 2 x 240 watt (1 khz, thd 1%) cap248 2 x 480 watt cap424 4 x 240 watt cap448 4 x 480 watt frequency response 50 hz - 18 khz signal to noise ratio > 90 db total harmonic distortion + noise common mode rejection 70 db cros...
Page 15
15 power consumption idle cap224/248 50 watt cap424 /448 89 watt 1/8 rated power cap224 115 watt cap248 187 watt cap424 218 watt cap448 440 watt 1/3 rated power cap224 221 watt cap248 400 watt cap424 435 watt cap448 870 watt weight cap224 7.2 kg cap248 7.5 kg cap424 8.35 kg cap448 8.85 kg.
Page 16: Notes
16 notes.